New Design New upgrade Foldable Solar Lights Instruction
How to Use Foldable Solar Lights
A. Foldable Solar light & Accessories:
1. One set of foldable solar light, including solar panel, batteries, controller, light source, etc., installation completed as Figure.1;
2. Remote control, including 2 PCS of 5# dry cells, to set and control the solar light.

foldable solar lights
B. Installed location of foldable solar light:
1. The solar light should be installed in a place of sufficient sunshine, and the solar panel should be adjusted to a proper angle, to receive the solar energy maximum.
2. Make sure no trees or buildings cover the solar panel.
C.Settings of solar light:
1. The solar panel should be activated in the sunlight before use.
2. The light can be turned on and off automatically by solar panel sensing, with no intervention.
3. Press the “test” key to verify the working condition.
4. Instructions manual of remote control as attached.
5. Related parameters have been set before delivery from the factory, modify data is only necessary when your local working time changed a lot, then you can modify the “N Load Pow Set” function by setting discharge time and power under professionals in case damage.
D. Setting different power in different time periods, the steps are as follows:
1. Press the “parameters” key in the lower left corner of the remote control as figure 3, and the screen will turn on. The controller will be auto-connected by a sound after 5-10 seconds of waiting, “Send Succeeded” means connected in Figure 2, while “Send Failed” means not connected, the controller is only available for use under the “Send Succeeded” status.
2. Press the “+” or “-” key as figure 4, the screen switched to “N Load Pow Set”, then press the “Set” key to enter.
3. The first time period set in figure 5,
a is for the working time setting (set for 2 hours),
b is for the percentage of lighting power setting when detecting movement (set for 100% brightness),
c is for the percentage of lighting power setting when no movement is detected (set for 30% brightness),
4. The second time period set in figure 6,
d is for the working time setting (set for 2 hours),
e is for the percentage of lighting power setting when detecting movement (set for 70% brightness),
f is for the percentage of lighting power setting when no movement is detected (set for 30% brightness);
5. The third time period set in figure 7,
g is for the working time setting (set for 6 hours),
h is for the percentage of lighting power setting when detecting movement (set for 50% brightness),
i it was for the percentage of lighting power setting when no movement is detected (set for 30% brightness),
6. The fourth time period set in figure 8,
j is for the working time setting (set for 1 hour),
k is for the percentage of lighting power setting when detecting movement (set for 30% brightness), l is for the percentage of lighting power setting when no movement is detected (set for 0% no brightness);
Suppose the light is working from 19:00pm, the remote control setting for instance as follows,
The 1st time period (Figure 5) is 19:00 pm to 21:00 pm, with 100% full brightness when movement is detected, and 30% brightness when no movement detected.
The 2nd time period (Figure 6) is 21:00 pm to 23:00 pm, with 70% brightness when movement is detected, and 30% brightness when no movement detected.
The 3rd time period (Figure 7) is 23:00 pm to 5:00 am, with 50% brightness when movement is detected, and 30% brightness when no movement is detected.
The 4th time period (Figure 8) is 5:00 am to 6:00 am, with 30% brightness when movement is detected, and 0% brightness when no movement is detected.

foldable solar lights data
know more from https://www.facebook.com/ViewdomTech
Leave A Comment